Lenze MCH Series Drives Metasys N2 Manual de usuario

MCH Series Drives Metasys N2 Communications Guide

7 RG-MHMETN2 Points4.2 Analog Input (AI) Point DescriptionsPoint Description1-01: Actual Frequency This point represents the actual speed of th

RG-MHMET 8N2 PointsPoint Description1-08: PID Setpoint Command This point is for monitoring the commanded PID Setpoint and is displayed in the dri

9 RG-MHMETN2 Points4.3 Binary Input (BI) Point DescriptionsPoint Description2-01: PID Mode This point is for monitoring the general state of th

RG-MHMET 10N2 Points4.4 Analog Output (AO) Point DescriptionsPoint Description3-01: Acceleration Rate This point sets the time that it will take

11 RG-MHMETN2 PointsPoint Description3-05: Keypad Setpoint Command This point monitors and controls the Keypad Setpoint Command. The units for t

Lenze AC Tech Corporation630 Douglas Street • Uxbridge MA 01569 • USASales: 800-217-9100 •Service: 508-278-9100www.lenze-actech.comRG-MHMET-e6

This documentation applies to the use of an MCH Series Variable Frequency Drive with Metasys N2 protocol and should be used in conjunction with

i RG-MHMETContents1 Safety Information ...

1 RG-MHMETSafety Information1 Safety Information1.1 Warnings, Cautions and Notes1.1.1 GeneralSome parts of Lenze controllers (frequency inverter

RG-MHMET 2Safety Information1.1.4 Electrical ConnectionWhen working on live drive controllers, applicable national regulations for the prevention of

3 RG-MHMETIntroduction2 IntroductionThis document will explain how to operate a Lenze-AC Tech MCH Variable Frequency Drive using Metasys N2 proto

RG-MHMET 4Drive Setup & Programming3 Drive Setup and ProgrammingMost drive parameters (including those required for serial communications) are n

5 RG-MHMETDrive Setup & Programming60 SERIAL TIMEOUT This parameter makes the serial watchdog timeout period selectable. It has a m

RG-MHMET 6N2 Points4 MCH N2 PointsThe MCH N2 Points are divided into four types: analog input, binary input, analog output and binary output. Sectio