Lenze PLC Designer R3-x Manual de usuario descargar pdf (Pagina 45)

Lenze · Commissioning of Lenze drives · 1.3 EN - 06/2014 45

Working with the sample projects

Sample project with "Table positioning" application - TablePositioning

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

7.2.6 Operation via the visualisations in the »PLC Designer«

7.2.6.1 Information/start page

[7-6] Example: Visualisation start page of the sample project Lenze 8400 HighLine - TablePositioning

• Via the buttons in area , the mode (automatic, manual, service, homing) can be selected.

•In area , SDO services (read/write parameters) for the controller can be selected.

• The button in area  refers to the start page which displays the version identifier of the project

and the libraries in area .

• Dialog box shows the status of the machine.

• Control field  shows the bus communication status.

• Control field Error indicates the error message status.

• Error in the application

• Error in the controller

•The Error Reset button resets the error messages.

 Select mode  Manufacturer information Status

Parameter

selection

 Information/home page  Status

 Note!

If a bus communication error occurs, the control and drive controller are to be restarted,

since the sample application does not support an automatic reset of bus

communication.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 158 159

Sin comentarios

Lenze PLC Designer R3-x Manual de usuario Pagina 45