Lenze PLC Designer PLC Designer (R2-x) Manual de usuario descargar pdf (Pagina 372)

100

101

L-force | PLC Designer

The Resources

370 DMS 3.2 EN 02/2011 TD29 

Module parameters of a DP slave

The module parameters dialog of a DP slave matches that of the other modules. The

parameters assigned to the slave in addition to the DP and user parameters in the

configuration file are displayed here, and the values can be edited in the standard

case.

Properties of a DP slave in slave operation of the Profibus

If a Profibus runs in slave mode, the slave device is inserted in the master level of the

configuration tree. The configuration can be done in the following dialogs (for a

description see the chapters above) :

• Base parameters

• DP parameters

• Module parameters

• Input/Output

8.2.5 Configuration of CANopen Modules...

»PLC Designer« supports a hardware configuration according to CANopen Draft

Standard 301. The configuration looks like that described for the hardware dependant

configuration.

All EDS (Electronic Data Sheet) respectively DCF (Device Configuration File) files which

are stored in the configuration files directory »PLC Designer« is started, can be

integrated, edited and displayed in the configuration. In the EDS file the configuration

options of a CAN module are described. If you add a module, which is described in a

DCF file, only the IEC addresses can be modified, for the module has already been

configured completely in a CAN configurator.

The CAN modules get a configuration which describes their time- and error-

dependant behaviour during the exchange of messages (dialog 'CAN Parameters of a

CAN Module'). Further on for each module the mapping of the PDOs (Process Data

Objects), serving for sending and receiving (dialogs 'Receive…’ resp. ‘Send PDO-

Mapping’). The values of the available SDOs (Service Data Objects) can be adapted

(dialog 'Service Data Objects').

Additional parameters of a CAN module resp. CAN Master, specified in the device

description file can be configured in dialog 'Modulparameters'.

If a PLC Designer-programmable PLC should be integrated in a CAN network as a

CANopen slave (also named „CANopen node“ and in the following called „CAN

device”), it can be configured in the PLC Designer PLC configurator and the

configuration can be stored in form of a EDS-file. This device description file then can

be used in any desired CANopen Master configuration.

1 2 ... 367 368 369 370 371 372 373 374 375 376 377 ... 843 844

Lenze PLC Designer PLC Designer (R2-x) Manual de usuario Pagina 372

Comentarios a estos manuales

Lenze PLC Designer PLC Designer (R2-x) Manual de usuario Pagina 372

Comentarios a estos manuales

Relacionado con productos y manuales para Software Lenze PLC Designer PLC Designer (R2-x)