Lenze PLC Designer PLC Designer (R2-x) Manual de usuario descargar pdf (Pagina 359)

100

101

L-force | PLC Designer

The Resources

 DMS 3.2 EN 02/2011 TD29 357

The module – except for BusMemberID – uses the same input and output

parameters. The parameters STATE and EXTENDEDINFO however have the

following, different meaning:

STATE:INT; If READY = TRUE then STATE gets one of the following values

which define the actual bus state:

BUSSTATE_BUSOK (Bus is running correctly)

BUSSTATE_BUSFAULT (Bus error)

BUSSTATE_BUSNOTCOMMUNICATING (Communication error)

BUSSTATE_BUSSTOPPED (Bus is stopped)

EXTENDEDINFO:ARRAY[0..129] OF

BYTE;

Manufacturer specific diagnosis data of the bus member; only

the first three bits of the byte are used:

Bit 0: bus member is configured

Bit 1: bus member is active

Bit 2: bus member reports an error, detailled information can

be get via DiagGetState() *)

Module parameters / Custom parameters of an I/O Module

Module parameters Dialog

In this dialog the parameters which are given by the device file are shown. Only the

column 'value' is editable.

Index: The Index is a consecutive digit (i), which numbers through all the way the

parameters of the module.

Name: Name of the parameter

1 2 ... 354 355 356 357 358 359 360 361 362 363 364 ... 843 844

Comentarios a estos manuales

Sin comentarios

Lenze PLC Designer PLC Designer (R2-x) Manual de usuario Pagina 359

Comentarios a estos manuales

Relacionado con productos y manuales para Software Lenze PLC Designer PLC Designer (R2-x)