Lenze PLC Designer PLC Designer (R2-x) Manual de usuario descargar pdf (Pagina 160)

100

101

L-force | PLC Designer

The Individual Components

158 DMS 3.2 EN 02/2011 TD29 

The version of the reference project can be accepted for single differences or for 'all

equally marked' differences. To accept means that the version of the reference project

is taken over to the actual project.

Please note: In compare mode (see status bar: COMPARE) the project cannot get

edited !

6.3.26 Execute comparison

After executing the command 'Project' 'Compare' the dialog Project Comparison

opens:

Dialog for Project Comparison

Insert the path of the reference project at Project to compare. Press button if you

want to use the standard dialog for opening a project. If you insert the name of the

actual project, the current version of the project will be compared with the version

which was saved last.

If the project is under source control in an ENI data base, then the local version can be

compared with the actual version found in the data base. For this activate option

Compare with ENI-Project.

The following options concerning the comparison can be activated:

Ignore whitespaces: There will be detected no differences which consist in a different

number of whitespaces.

Ignore comments: There will be detected no differences in comments.

Ignore properties: There will be detected no differences in object properties.

1 2 ... 155 156 157 158 159 160 161 162 163 164 165 ... 843 844

Comentarios a estos manuales

Sin comentarios

Lenze PLC Designer PLC Designer (R2-x) Manual de usuario Pagina 160

Comentarios a estos manuales

Relacionado con productos y manuales para Software Lenze PLC Designer PLC Designer (R2-x)