Lenze PLC Designer PLC Designer (R2-x) Manual de usuario descargar pdf (Pagina 309)

100

101

L-force | PLC Designer

Editors in PLC Designer

 DMS 3.2 EN 02/2011 TD29 307

'Insert' 'Contact' in LD

Symbol:

Shortcut: <Ctrl>+<K>

Use this command in the LD editor in order to insert a contact in front of the marked

location in the network.

If the marked position is a coil or the connecting line between the contacts and the

coils, then the new contact will be connected serially to the previous contact

connection.

The contact is preset with the text "???". You can click on this text and change it to the

desired variable or the desired constant. For this you can also use the Input Assistant.

Regard the possibility of entering an address instead of the variable name, if this is

configured appropriately in the 'Function Block and Ladder Diagram Options' (see

Chapter 5.4.1: Comments, Linebreaks, 'Extras' 'Options').

Also in the options dialog you can activate the options Comments per Contact and

Lines for variable comment and reserve a certain number of lines for the variable

name. This might be useful, if long variable names are used, to keep the network

short.

Also regard the option Networks with linebreaks, which you also can activate in the

Ladder Diagram Options.

'Insert' 'Contact (negated)' in LD

Symbol:

Shortcut: <Ctrl> + <G>

This command inserts a negated contact. The same is true as for the commands

'Insert' 'Contact' and 'Extras' 'Negate', which in combination also could be used to

insert a negated contact.

1 2 ... 304 305 306 307 308 309 310 311 312 313 314 ... 843 844

Comentarios a estos manuales

Sin comentarios

Lenze PLC Designer PLC Designer (R2-x) Manual de usuario Pagina 309

Comentarios a estos manuales

Relacionado con productos y manuales para Software Lenze PLC Designer PLC Designer (R2-x)