Lenze PLC Designer PLC Designer (R2-x) Manual de usuario descargar pdf (Pagina 333)

100

101

L-force | PLC Designer

Editors in PLC Designer

 DMS 3.2 EN 02/2011 TD29 331

'Extras' 'EN/ENO' in CFC

Symbol:

Shortcut: <Ctrl> + <I>

This command is used to give a selected block (Cursor position 3) an additional

Boolean enable input EN (Enable In) and a Boolean output ENO (Enable Out).

ADD is only executed in this example when the Boolean variable "condition" is TRUE.

VarOut will also be set to TRUE after the execution of ADD. But if afterwords condition

changes to FALSE, ADD will not be executed any more and thus VarOut remains TRUE!

The example below shows how the value ENO can be used for further blocks:

x should initialised to 1 and y initialised to 0. The numbers in the right corner of the

block indicate the order in which the commands are executed.

x will be increased by one until it reaches the value 10. This causes the output of the

block LT(0) to deliver the value FALSE and SUB(3) and ADD(5) will be executed. x is set

back to the value 1 and y is increased by 1. LT(0) is executed again as long as x is

smaller than 10. y thus count the number of times x passes though the value range 1

to 10.

1 2 ... 328 329 330 331 332 333 334 335 336 337 338 ... 843 844

Comentarios a estos manuales

Sin comentarios

Lenze PLC Designer PLC Designer (R2-x) Manual de usuario Pagina 333

Comentarios a estos manuales

Relacionado con productos y manuales para Software Lenze PLC Designer PLC Designer (R2-x)