Lenze EVS9332xK Manual de usuario descargar pdf (Pagina 184)

Function library

Function blocks

3.2.44 Digital frequency processing (DFSET)

3−156

EDSVS9332K−EXT EN 4.0

Phase trimming

This adds a setpoint at DFSET−A−TRIM to the phase setpoint (see code C0536/3) and changes the

rotor position to the setpoint with the number of increments provided in either direction (drive is

leading or lagging). The phase is trimmed within a range of ±32767 increments (¢ ±1/2 rev.). Every

analog signal can be used as a source.

l The input is done in increments (one revolution ¢ 65536 increments).

l When analog values are entered, 100% correspond to 1/4 revolution = 16384 increments.

l Extension of the setting range with a multiplier under C0529.

Phase offset

Addition of a fixed phase offset under C0252 to the setpoint of the drive.

Speed−proportional phase setting

Leading or lagging of the phase with rising speed.

l Enter a suitable setting in increments under code C0253.

l The set phase offset is reached at 15000 rpm of the drive (linear relationship).

3.2.44.3 Synchronising to zero track or touch probe

The synchronisation is selected under C0532.

l C0532 = 1, index pulse

– zero track of digital frequency input X9 and zero track by the feedback system set under

C0490 (not for resolver evaluation).

l C0532 = 2, touch probe

– via terminals X5/E4 (actual pulse) and X5/E5 (set pulse).

l C0532 = 3, zero pulse (setpoint) and TOUCH−PROBE (actual value)

– Zero track from the digital frequency input X9 for the setpoint and touch probe initiator via

terminal X5/E4 for the actual value.

) Note!

All three modes provide the possibility to define a divisor factor for the actual pulses

with codes C0531 as well as for the setpoint pulses with codes C0535 (default

setting = 1). Hence, it is possible to e.g. evaluate every 10th actual pulse if C0531 =

10. The other 9 pulses are ignored.

Touch probe initiators can have delay times which cause a speed−dependent phase offset.

To take this angular offset into account, the response time [ms] of the initiators is converted into an

angular correction depending on setpoint speed DFSET−NOUT and then considered in the setpoint

angle. For this purpose, the response time [ms] must be converted into a correction value [Inc.] first.

l Set correction value for the phase offset under C0430.

l Formula for the input value in C0430/x:

EingabewertinC0430ńx + 16384 @ Ansprechzeit[ms]

l Please take the response time [ms] from the data sheet of the initiator or contact the

manufacturer.

1 2 ... 179 180 181 182 183 184 185 186 187 188 189 ... 385 386

Lenze EVS9332xK Manual de usuario Pagina 184

Comentarios a estos manuales

Lenze EVS9332xK Manual de usuario Pagina 184

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Lenze EVS9332xK