Lenze PLC Designer ApplicationTemplate (PLC Designer R3- Manual de usuario descargar pdf (Pagina 82)

Architecture: The ApplicationTemplate in detail

State machine

Lenze · ApplicationTemplate · 1.3 EN - 04/2013

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

9.3.4 Mapping of the states - Enum L_EATP_SMStates

The different states of the state machine are mapped in the L_EATP_SMStates enumeration.

L_EATP_SMStates

( 130)

9.3.5 Activating the states - baseChannelSetNominalState method

The ApplicationTemplate provides methods to set the machine modules to a specific state.

 Note!

This method can be used if...

• ...the .DisableDefaultCouplingSlave function (module's intrinsic target status)

The "DisableDefaultCouplingMaster" function

( 85) is activated, or

• ...the .DisableDefaultCouplingMaster function (target status of a slave module) is

activated. The "DisableDefaultCouplingSlave" function

( 86)

• ...the machine control module (MM in the top level of the MachineModuleTree

(MMT)) sets itself to a specific state, so that the subordinated modules change to the

same

status.

Method name Transfer value/data type Description

baseChannelSetNominalState Set the target status of the state

machine for the corresponding slave

module/own module.

MM_Address

L_EATP_MM_Address

• Address of the module the current

state of which is to be queried.

• The value "0" and the

L_EATP_CONST.OWNID constant

address the module's intrinsic ID.

eState

L_EATP_SMStates

• Setpoint status to be set.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 176 177

Sin comentarios

Lenze PLC Designer ApplicationTemplate (PLC Designer R3- Manual de usuario Pagina 82