Lenze PLC Designer ApplicationTemplate (PLC Designer R3- Manual de usuario descargar pdf (Pagina 33)

Lenze · ApplicationTemplate · 1.3 EN - 04/2013 33

Opening the ApplicationTemplate

Going online

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

7.3 Going online

In order to be able to establish an online connection to the controller, the communication settings

(Set active path) must be commissioned before. Establishing communication with the controller

( 13)

7.3.1 Compiling the project data

To compile the project data, select the BuildBuild menu command or press the <F11> function

key.

• If errors occur during the compilation, they are to be localised on the basis of the »PLC Designer«

error messages and corrected correspondingly. Recompile the project data afterwards.

• If no errors occur during the compilation, the »PLC Designer« project must be saved:

File Save project

7.3.2 Transferring the project to the control - "Log in"

The desired project must be transferred to the PLC device by "Logging in" to the controller: Call menu

command Online Log in.

7.4 Loading and starting the PLC program

• Load the PLC program to the controller: Call OnlineLoad menu command.

• Start the PLC program: Call OnlineStart menu command.

• As an alternative, you can execute the DebugStart menu command or press <F5>.

 Tip!

In order to load a project automatically after a device is restarted, it can be defined as

"boot project".

Setting up the project as boot application

 How to install the project as boot project:

1. Select the OnlineGenerate boot project for L-force Controller menu command.

 Note!

To "log in" the PLC program must be error-free. For this it must be possible to execute the

BuildBuild (F11) menu command without an error message.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 176 177

Sin comentarios

Lenze PLC Designer ApplicationTemplate (PLC Designer R3- Manual de usuario Pagina 33