Lenze CANopen control technology Manual de usuario Pagina 82

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 105
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 81
Control technology | CANopen communication manual
Commissioning the CANopen Motion bus
Creating a program code to control the Motion drives
82 L DMS 4.2 EN 07/2011 TD17
9.6 Creating a program code to control the Motion drives
This depends on the automation task, the use of PLCopen blocks or the CNC programming.
See also "Creating a program code to control the device
" (chapter [8.8] ( 65)).
9.7 Preparing the restart
Save parameter set of the drive via the »Engineer« or the »Global Drive Control«.
Please also see "Preparing the restart
" (chapter [8.9] ( 68)).
Note!
All SoftMotion function blocks, SoftMotion functions, and the read/write block
parameters that access the SoftMotion drives (e.g. MC_WriteParameter,
MC_WriteBoolParameter, LenzeECSReadParameter, LenzeECSWriteParameter)
may only be called from the Motion task.
If they are called from another task, their execution may be incorrect.
Vista de pagina 81
1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 104 105

Comentarios a estos manuales

Sin comentarios