Lenze Engineer v2.21 Manual de usuario descargar pdf (Pagina 283)

Lenze · Engineer · 2.13 EN - 10/2014 283

Appendix

Creating cam data with the »Cam Editor«

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

14.3.2 Creating curves

14.3.2.1 Step 1: Basic settings

You can adapt the basic settings for the curve to be created (the motion profile or the characteristic).

This is done in the dialog box entitled Cam Designer settings.

 How to proceed:

1. Right-click the desired curve in the Project tree.

2. Execute the Edit Object Settings ... command to open the Cam Designer Settings

dialog box.

 Note!

When creating curves or characteristics in the »Cam Designer«, the following

technological restriction is to be observed:

• If linear sections are created in a curve and these sections encompass more than half

the maximum value range (i.e. more than 200 %), they must be represented with at

least three interpolation points.

• In practice, this means that, in the case of linear sections that exceed the zero line, an

interpolation point must be at the zero crossing or in the middle of the segment. In

cases of doubt, the linear progression should be entered manually with two sections.

For position curves in the Modulo measuring system, this restriction is not

relevant

because, in this case, the permissible value range is adhered to automatically.

1 2 ... 278 279 280 281 282 283 284 285 286 287 288 ... 311 312

Sin comentarios

Lenze Engineer v2.21 Manual de usuario Pagina 283