Lenze Engineer v2.21 Manual de usuario descargar pdf (Pagina 254)

Error messages

Communication entity generator

254

Lenze · Engineer · 2.13 EN - 10/2014

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

Error during writing of parameter value {0} [CE94CAN0003]

Node with SYNC source property must be NMT master [CE94CAN0004]

Predefined connection set active [CE94CAN0005]

Response (Lenze setting printed in bold)

 Error  Warning  Information

Cause Remedy

Parameter value could not be written to the code.

Response (Lenze setting printed in bold)

 Error  Warning  Information

Cause Remedy

A special feature of the 9400 is that, when it is to send a

synchronisation object, it must be the NMT master at the

same time.

• Go to the network which is assigned to the device.

• Highlight the corresponding node in the Node tab.

• The node is enclosed in green.

• Select

Set NMT master from the context menu of the right

mouse button.

• The master node has a black triangle in the right

corner at the bottom.

Nodes

( 216)

Response (Lenze setting printed in bold)

 Error  Warning  Information

Cause Remedy

Node is not connected to a CAN network. In the Settings

tab of the node, the control field Use Predefined

Connection Set was selected. During the compilation,

the settings for COB-IDs, SYNC, etc. were assigned in

accordance with CANopen.

This message is information for the user.

1 2 ... 249 250 251 252 253 254 255 256 257 258 259 ... 311 312

Sin comentarios

Lenze Engineer v2.21 Manual de usuario Pagina 254