Lenze DDS Target 9300 Servo PLC V8.x Manual de usuario descargar pdf (Pagina 125)

9300 Servo PLC

Appendix

3.6 Code table

3−119

9300 Servo PLC EN 5.1

3.6 Code table

How to read the code table:

Column Abbreviation Meaning

Code C0168

…

Code C0168

Subcode 1 of code C0168

Subcode 2 of code C0168

…

Subcode 8 of code C0168

[C0156] Parameter value of code can only be changed when controller is inhibited.

LCD Keypad LCD

Lenze

Lenze setting of the code

g Display code (can only be displayed)

 The "info" column contains more information.

Selection 1 {1 %} 99 Minimum value {smallest step/unit} maximum value

Informati

Additional information on code

Code LCD

Possible settings

Information

Lenze Selection

[C0002] Par load 0 Load parameter set

 Only possible when PLC has been stopped.

 Parameter set 1 is automatically loaded after

power−on.

0 Load Lenze setting into RAM

1 Load parameter set 1 into RAM

2 Lenze setting and codes−

Load initialisation values into RAM

C0003 Par save 0 Save parameter set

 Also possible when PLC is in operation.

0 Saving completed

1 Non−volatile saving of parameter set 1

C0004 Op display 56 Keypad operating display

 Keypad will indicate selected code in the operating

level if no other status indications of C0183 are active.

All available codes

[C0006] Op mode  Operating mode of the motor control

 Dependent on C0086

 If C0086 is changed, the value is reset to the assigned

Lenze setting.

 Change of C0006 sets C0086 = 0.

 ESC (Extended Speed Control):

Speed control with increased speed control steadiness

for operation with incremental encoder only (not

resolver!).

2 Servo async Y Servo control for asynchronous motors in star connection

3 Servo PM−SM Y Servo control for synchronous motors in star connection

22 Servo async Servo control for asynchronous motors in delta connection

31 ASM Y − ESC Servo control for asynchronous motors in star connection,

ESC

32 PM−SM Y − ESC Servo control for synchronous motors in star connection,

ESC

33 ASM − ESC Servo control for asynchronous motors in delta connection,

ESC

C0009 LECOM address 1 LECOM controller address

(bus device number for operation via interface)

 10, 20, ..., 90 reserved for broadcast to device groups

for RS232, RS485, fibre optics.

1 {1} 99

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 168 169

Comentarios a estos manuales

Sin comentarios

Lenze DDS Target 9300 Servo PLC V8.x Manual de usuario Pagina 125

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Lenze DDS Target 9300 Servo PLC V8.x