Lenze E94AxHE Technology Application Electronic gearbox Manual de usuario descargar pdf (Pagina 25)

EDS94TA10030xxxx EN 1.2 - 11/2009 L 25

9400 Technology applications | Electronic gearbox

Short setup

Step 1: Creating a project

4.3 Step 1: Creating a project

 Tip!

Since the components of the master and slave axis are identical in the application

example, you can use the copy&paste function to create the project in the

»Engineer«:

• In the first step, only insert the master drive axis.

• Then, parameterise the technology application "Electronic gearbox" for the

master drive.

• When the required settings have been made, copy the master axis in the project

view, paste it, and rename it.

1. Start »Engineer«.

2. Go to Start-up wizard and select the option "New project (empty)" and enter a name for

the project in a next step.

3. Insert the axis for the master drive.

– Add the corresponding components to the axis (controller, motor, digital frequency

extension module).

– Select the application "Electronic gearbox" for the controller. (Do not select

"Electronic gearbox MotionBus" because the digital frequency extension module is

only supported by the variant without MotionBus.)

–Example project view in the »Engineer«:

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 79 80

Sin comentarios

Lenze E94AxHE Technology Application Electronic gearbox Manual de usuario Pagina 25