Lenze E94P PositionServo with MVOB Manual de usuario descargar pdf (Pagina 78)

76 L PM94H201B_13xxxxxx_EN

Programming

2.15.9.18 Homing Method 21: Homing to Homing Switch (without index pulse)

Using this method the initial direction of movement is negative (if the homing switch is inactive). The home position is

the leading edge of the homing switch.

Axis will accelerate to fast homing velocity in the negative direction and continue until the homing switch is activated

(rising edge) shown at position A. Axis then decelerates to zero velocity.

If the homing switch is already active when the homing routine commences then this initial move is not executed.

Axis will then accelerate to fast homing velocity in the positive direction. Motion will continue until the falling edge of the

homing switch is detected (position B), where the axis will decelerate to 0 velocity.

Axis will then accelerate to slow homing velocity in the negative direction. Motion will continue until the rising edge of

the homing switch is detected (position C), where the axis will decelerate to 0 velocity.

Axis will then accelerate to slow homing velocity in the positive direction. Motion will continue until the falling edge of

the homing switch is detected (position 21). This is the home position (excluding offset).

Homing Switch

(Var_Home_Switch_Input)

Figure 42: Homing Method 21

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 139 140

Sin comentarios

Lenze E94P PositionServo with MVOB Manual de usuario Pagina 78