Lenze PROFIBU PC-based Automation Manual de usuario Pagina 16

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 69
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 15
Control technology | PROFIBUS communication manual
The Lenze control system with PROFIBUS
Brief description of PROFIBUS
16 L DMS 2.2 EN 07/2011 TD17
Parameter setting
The PROFIBUS stations can be parameterised in different ways:
Direct access of the engineering software (from the engineering PC) to the slave field
device. Depending on the device type, via the following interfaces:
–CAN
Ethernet
LECOM
Diagnostic interface
Parameter transfer from the control (the parameter transfer must be programmed
manually)
PROFIBUS is exclusively configured with the »PLC Designer«:
Structure of the control configuration and creation of the PLC program
All PROFIBUS slaves can be switched on via device data base files (GSE files).
Note!
The "IPC as gateway" function is not available in connection with PROFIBUS.
Thus, "Going online" with the »Engineer« or the »GDC« via the IPC as gateway is
not possible.
Vista de pagina 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 68 69

Comentarios a estos manuales

Sin comentarios