Lenze ECSEAxxx Manual de usuario descargar pdf (Pagina 93)

Electrical installation

Installation according to EMC (installation of a CE−typical drive system)

5



93

EDKCSEX064 DE/EN/FR 6.0

5 Electrical installation

5.1 Installation according to EMC (installation of a CE−typical drive system)

General information

ƒ The electromagnetic compatibility of a machine depends on the type of

installation and care taken.Especially consider the following:

– Assembly

– Filtering

– Shielding

– Earthing

ƒ For diverging installations, the evaluation of the conformity to the EMC

Directive requires a check of the machine or system regarding the EMC

limit values. This for instance applies to:

– Use of unshielded cables

– Use of collective interference filters instead of the assigned RFI filters

– Operating without RFI filters

ƒ The compliance of the machine application with the EMC Directive is in

the responsibility of the user.

– If you observe the following measures, you can assume that the

machine will operate without any EMC problems caused by the drive

system, and that compliance with the EMC Directive and the EMC law is

achieved.

– If devices which do not comply with the CE requirement concerning

noise immunity EN 61000−6−2 are operated close to the ECS modules,

these devices may be electromagnetically affected by the ECS modules.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 199 200

Comentarios a estos manuales

Sin comentarios