Lenze MC3000 Series Drives Manual de usuario

MC3000 Series Drives Metasys N2 Communications Guide

7 RG-MCMETN2 Points4.1 Metasys N2 Point MapTable 3: Metasys N2 Point Map for MC3000 Series DrivesPointType 1Point #Description (Point Name) Read (

RG-MCMET 8N2 Points4.2 Analog Input (AI) Point DescriptionsPoint Description1-01: Parameter Version The entries in Table 1 are based upon Pa

9 RG-MCMETN2 PointsPoint Description1-05: Drive Class This point represents the MC series drive class = 65 (41h).1-06: Total Runtime Hours Thi

RG-MCMET 10N2 PointsPoint Description1-11: Present Fault This point indicates the type of fault on which the drive is currently tripped. This poin

11 RG-MCMETN2 PointsPoint Description1-20: PID FeedbackThis point monitors the current state of the PID Feedback. If the drive is running in Loca

RG-MCMET 12N2 PointsPoint Description3-03: Normal Acceleration This point sets the time that it will take for the drive to ramp up the motor from

13 RG-MCMETN2 PointsPoint Description3-06: Control Mode This point allows the user to manipulate the control mode in which the drive is running.

RG-MCMET 14N2 PointsPoint Description4-03: Auto/Manual Select - ContimuedA/M LOC If parameter 28 is set to A/M LOC, then the drive can be set to g

Lenze AC Tech Corporation630 Douglas Street • Uxbridge MA 01569 • USASales: 800-217-9100 •Service: 508-278-9100www.lenze-actech.comRG-MCMET-e6

This documentation applies to the use of an MC3000 Series Variable Frequency Drive with Metasys N2 protocol and should be used in conjunction with the

i RG-MCMETContents1 Safety Information ...

1 RG-MCMETSafety Information1 Safety Information1.1 Warnings, Cautions and Notes1.1.1 GeneralSome parts of Lenze controllers (frequency inverter

RG-MCMET 2Safety Information1.1.4 Electrical ConnectionWhen working on live drive controllers, applicable national regulations for the prevention of

3 RG-MCMETIntroduction2 IntroductionThis document will explain how to operate a Lenze-AC Tech MC3000 Variable Frequency Drive using M

RG-MCMET 4Drive Setup & Programming3 Drive Setup and ProgrammingMost drive parameters (including those required for serial communications) are n

5 RG-MCMETDrive Setup & Programming57 SERIAL Must be set to WITH TIMER (default) or W/O TIMER for the drive to communicate with the N2 Network

RG-MCMET 6N2 Points4 MC3000 N2 PointsThe entries in Table 3 are based upon MC3000 Drive Software Version 213-043 Revision 05 (Parameter Version 143)