Lenze EMZ9374IB Manual de usuario descargar pdf (Pagina 60)

Commissioning

Configuration with internal DIP switches

Settings in the operating mode (normal operation)

EDBMZ9374X DE/EN/FR 4.2

7.3.2 Settings in the operating mode (normal operation)

(Carry out settings only when the power supply is switched off!)

In the operating mode carry out the following settings:

ƒ Addressing of the terminal extension

ƒ Number of terminal extensions used

ƒ Setting the CAN bus baud rate

DIP switch assignment in operating mode

DIP switch Function Setting notes Note

Setting the

CAN bus

node address

DIP switches 1 ... 6 are used to set the

address of the terminal extension.

The table "Addressing of the terminal

extension" shows the switch settings.

A maximum number

of 63 addresses are

available.

Number of

terminal

extensions

on one

address

You can operate maximal 4 terminal

extensions on one device address.

Baud rate

setting

The table "Setting the baud rate" shows

the switch settings.

^ 63

12 Programming

mode /

Operating

mode

Set the DIP switch to OFF (operating mode) When the operating

mode is set, the LED

"operation" is on.

Set operating mode:

1. Check whether DIP switch 12 is set to OFF (operating mode).

2. Switch on the power supply for the terminal extension.

– Operating mode is active.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 121 122

Comentarios a estos manuales

Sin comentarios

Lenze EMZ9374IB Manual de usuario Pagina 60

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Lenze EMZ9374IB