Lenze E84AYCEC Manual de usuario descargar pdf (Pagina 9)

EDS84AYCEC EN 3.0 - 09/2012 L 9

E84AYCEC communication manual (Ethernet POWERLINK)

About this documentation

Terminology used

1.3 Terminology used

Term Meaning

Controller Lenze controllers of the "Inverter Drives 8400" series

Standard device

»Engineer« Lenze PC software which supports you in "engineering" (parameterisation,

diagnostics and configuration) throughout the whole life cycle, i.e. from

planning to maintenance of the commissioned machine.

Code Parameter used for controller parameter setting or monitoring. The term is

usually called "index".

Subcode If a code contains more than one parameter, these parameters are stored in so-

called "subcodes".

In this documentation a slash "/" is used as a separator between code and

subcode (e.g. "C00118/3").

The term is usually called "subindex".

Lenze setting This setting is the default factory setting of the device.

Basic setting

HW Hardware

SW Software

EPL Abbreviation for "Ethernet POWERLINK"

(EPL) nodes Ethernet POWERLINK nodes (Managing Node, Controlled Nodes)

CN Controlled node (EPL slave)

MN Managing node (EPL master)

The Managing Node accepts the control function for the data communication of

the decentralised field devices. Typically, the Managing Node is the

communication interface of a PLC.

Node ID EPL node address

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 88 89

Sin comentarios

Lenze E84AYCEC Manual de usuario Pagina 9