Lenze DDS v2.3 Manual de usuario descargar pdf (Pagina 188)

Drive PLC Developer Studio

Editors

7-66

DDS EN 2.3

Use Online➞

➞➞

➞Single step in to step into actions. Any entry, exit or IEC action to which a jump is to

be effected, must include a breakpoint. All debugging functions of the associated editor are

available inside transitions or actions.

Processing sequence of elements in a sequencer.

Tip!

The steps in a sequencer are processed from top to bottom and from left to right.

1. First, all Action Control Block Flags of IEC actions used in this sequencer are reset. The flags

of IEC actions that are called within actions remain set.

2. All steps in the sequencer are checked in their sequence in the sequencer as to whether the

condition to execute the exit action is fulfilled, and executed if so.

3. All steps are subject to the following procedure:

– The expired time is copied into the associated step variable.

– A timeout is checked, and SFC error flags are set accordingly.

– Only the associated action will be executed if the current step is not an IEC step.

4. The IEC actions of the sequencer are executed in alphabetical order. The list of actions is

processed twice, the first run executing all IEC actions deactivated in the current cycle, and

the second one executing all IEC actions active in the current cycle.

5. The transitions are evaluated, and the next step is activated, if the following conditions are

fulfilled.

– The step in the current cycle was active.

– The subsequent transaction is TRUE.

– The minimum active time has expired.

Show/Hide Bookmarks

1 2 ... 183 184 185 186 187 188 189 190 191 192 193 ... 339 340

Sin comentarios

Lenze DDS v2.3 Manual de usuario Pagina 188