Lenze GSS Manual de usuario Pagina 30

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 80
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 29
Mechanical installation
Mounting
Preparation
5
l
30
BA 12.0023−EN 7.0
5.4 Mounting
5.4.1 Preparation
( Stop!
Thoroughly remove anticorrosion agents from output shafts and flange faces.
Correcting the oil quantity
If the oil quantity has been increased in the gearbox for long−term storage (see chapter
5.2), the oil must be completely drained and then filled in again for the corresponding
mounting position. The following steps must be observed:
1. Place receptacle under oil drain plug.
2. Remove ventilation / oil filler plug.
3. Completely drain lubricant.
4. Screw in oil drain plug.
5. Fill in oil quantity for the corresponding mounting position (^ 66).
6. Screw in ventilation / oil filler plug.
Condensation drain hole
) Note!
Lenze delivers motors with condensation drain holes with sealed condensation
drain holes. The holes are sealed with a plastic plug or a plug screw. This does
not impair the enclosure and the motor is protected against ingress of foreign
particles during transport and operation. For further information, please see
chapter 8.2.1.
Vista de pagina 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 79 80

Comentarios a estos manuales

Sin comentarios