Lenze EMF2112IB Manual de usuario descargar pdf (Pagina 34)

Parameter setting

6-12



BA2112EN

6.1.3 DRIVECOM control (C0009 ≠ 11, 12)

6.1.3.1 DRIVECOM status machine

Controllers 82XX, 8200 vector (C0001 ½ 3)

For standard control you enter the control information via the corresponding control inputs

(terminal):

Information about the current unit status (Fig. 6-3, see below) (rectangles) are available in the

DRIVECOM parameter “status word“. Commands in the DRIVECOM parameter “controlword“ are

switched off and cannot changethe controller status. The commands to changethe controller status

are entered via the corresponding control inputs. These commands are marked by arrows in the

following diagram.

Status word xxxx xxxx x0xx 0000

NOT READY TO SWITCH ON

QSP**

Ctrl. enable** Ctrl. inhibit**

automatically when

the initialization is

completed

TRIP (fault)

TRIP reset**

Switch on unit

READY TO SWITCH ON

Status word xxxx xxxx x01x 0001

SWITCHED ON

Status word xxxx xxxx x01x 0011

OPERATION ENABLED

Status word xxxx xxxx x01x 0111

automatically

Fault

Status word xxxx xxxx x0xx 1000

Note:

The terms marked with ** are

commands

Fig. 6-3 Status diagram for standard unit control

Status Meaning

NOT READY TO SWITCH

The controller is being initialized and is not yet ready to operate.

It then automatically switches to the status READY TO SWITCH ON.

READYTOSWITCHON The controller is inhibited and waits for the power stage to be charged. It then automatically switches to the status “SWITCHED ON“.

SWITCHED ON The controller is inhibited and waits for controller enable.

OPERATION ENABLED The controller is enabled. In this status, a pulse inhibit can be set automatically.

FAULT The controller is in the status “FAULT“ (TRIP).

Show/Hide Bookmarks

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 52 53

Comentarios a estos manuales

Sin comentarios

Lenze EMF2112IB Manual de usuario Pagina 34

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Lenze EMF2112IB