Lenze GDO getting started Manual de usuario descargar pdf (Pagina 22)

Global Drive Oscilloscope

20 GDO DE/EN 1.1

2 System requirements

For applying the oscilloscope f unction the following requirements must be met.

PC or laptop with:

• Microsoft Windows 98/NT (Service Pack 5) /2000 (Se rvice Pack 2) /XP

• IBM compatible PC (Pentium 166 processor or higher)

• 64 MB (RAM)

• 40 MB free hard disk capacity

• VGA graphics card

• CD-ROM drive

• Use of a mouse

In order to use the HTML online help, the Microsoft Internet Explorer 4.0 or higher is required.

Note!

The communication takes place via system bus (CAN).

Note!

If your computer is provided with a full DriveServer version, please add the System Bus server to the

DriveSer ver configuration. The Global Drive Oscilloscope exclusively communicates via the

DriveServer/System Bus Ser ver.

Please observe the DriveSer ver documentation!

2.1 Technical data for 9300 servo PLC V6.0

Memory depth max.16384 measured values.

• The value depends on the number of channels and size of the variables to be

recorded.

Memory capacity 16384 bytes

Data width of a channel corresponding to the size of the variables to be recorded

Number of channels 1...8

Trigger level Corresponding to the value range of the variables to be triggered

Trigger selection Immediate triggering, r ising edge, falling edge, signal change

Trigger delay -100%...+400%

Trigger source Channels 1-8, T rigger variable

Show/Hide Bookmarks

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28 29

Sin comentarios

Lenze GDO getting started Manual de usuario Pagina 22