Lenze ApplicationTemplate PackML (PLC Designer R3-x) Manual de usuario descargar pdf (Pagina 17)

Lenze · ApplicationTemplate PackML · 1.0 EN - 05/2014 17

What is the ApplicationTemplate PackML?

Elements of the ApplicationTemplate PackML

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

4.3.3 Addressing the machine modules

[4-4] Illustration example: Sample illustration MMT in the L_ApplicationTemplate sample project

The following must be observed when relative addresses are assigned to the machine modules:

•The relative address is to be assigned to every machine module (value range: 1...29).

• During the initialisation phase, the »PLC Designer« generates an absolute address for every

machine module.

• Example of the relative

and absolute module addressing:

The diagram shows the absolute module address (black) and the relative module address (white).

• In the event of an error, the absolute address enables an error analysis. This for instance makes

it possible to retrace the module which has caused the error in each case. Alarm handling

(error handling) ( 76)

4.3.4 Module application (MAP)

The module application (MAP) contains the function of the corresponding machine module.

• The ApplicationTemplate Pack ML supports up to three

tasks. Hence, up to three MAPs can be

used per machine module.

Every machine module has an

MM_Address input which

serves to assign the relative

address to the machine

module.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 98 99

Sin comentarios

Lenze ApplicationTemplate PackML (PLC Designer R3-x) Manual de usuario Pagina 17