Lenze MCH Series Drives Metasys N2 Manual de usuario descargar pdf (Pagina 12)

9 RG-MHMET

N2 Points

4.3 Binary Input (BI) Point Descriptions

Point Description

2-01: PID Mode

This point is for monitoring the general state of the drive’s PID mode. If Drive Parameter

#70 (PID Mode) is set to OFF this point returns 0 (DISABLED). If Drive Parameter #70 is set

to either NORMAL or REVERSE, then this point returns 1 (ENABLED).

2-02: Current Direction

This point indicates the direction in which the drive is currently running.

Point Description

2-03: Run / Stop Status

This point indicates whether or not the drive is currently running.

2-04: TB-14 / Relay #2

This point monitors the state of the drive’s TB-14 or Relay #2 output. This point can be

used to indicate various drive conditions as speciﬁed by Drive Parameter #52 (TB14/Relay

#2). Refer to the MCH Installation and Operation Manual (MH01) for more information.

2-05: TB-15 / Relay #3

This point monitors the state of the drive’s TB-15 or Relay #3 output. This point can be

used to indicate various drive conditions as speciﬁed by Drive Parameter #53 (TB15/Relay

#3). Refer to the MCH Installation and Operation Manual (MH01) for more information.

2-06: Relay #1

This point monitors the state of the drive’s Relay #1 output. This point can be used to

indicate various drive conditions as speciﬁed by Drive Parameter #54 (Relay #1). Refer to

the MCH Installation and Operation Manual (MH01) for more information.

2-07: Fault Condition

This point indicates whether or not the drive is currently tripped on a fault. This point

returns 0 (OK) if the drive is not in a fault condition or 1 (FAULT) if it is.

2-08: Serial Watchdog

This point indicates the state of the MCH drive's serial watchdog function. If Drive Parameter

#57 (Serial) is set to WITH TIMER and Point 4-02 is set to NORMAL, then this point returns

a value of 0 (ENABLED). If Drive Parameter #57 (Serial) is set to W/O TIMER or Point 4-02

is set to DISABLE, then this point returns a value of 1 (DISABLED).

1 2 ... 7 8 9 10 11 12 13 14 15

Sin comentarios

Lenze MCH Series Drives Metasys N2 Manual de usuario Pagina 12