Lenze E94P v2.0 Manual de usuario descargar pdf (Pagina 5)

5P940HBK01B

3 Connections

3.1 P3A - Controller Interface

The E94ZAHBK2 Motor Brake Module is mounted to the P3 connector on the face of the PositionServo drive

as illustrated in Figure 1. The P3A connector on the Brake Module is a pass-through SCSI connector from P3

except for pins 45 and 46.

Refer to the PositionServo Users Manaual, Section 5.1.3 for the P3 Pin Assignments.

Output 2 (Pins 45 and 46) are dedicated for controlling the Motor Brake on the E94ZAHBK2 module.

STOP!

Pins 45 and 46 on the SCSI connector P3A are dedicated to the control of the holding brake and are

brought out to the terminal block. DO NOT USE these pins on the SCSI connector without ﬁrst consulting

a Lenze / AC Tech Application Engineer.

Note

Do not use E94ZAHBK1 with the I/O Simulator module (E94ZATST1). The I/O Simulator uses OUT2 (Pins

45 and 46) for another purpose.

The P3A connector is for interfacing to front-end controllers. It is strongly recommended that OEM cables be

used to aid in satisfying CE requirements. Contact your PositionServo representative for assistance.

24 VDC

–

BRAKE

RELEASED

+ – + –

24VDC BRAKE

MOTOR BRAKE

MODULE

Figure 1: Installation of Motor Brake Terminal Module

•

1 2 3 4 5 6 7 8 9

Sin comentarios

Lenze E94P v2.0 Manual de usuario Pagina 5