Lenze PLC Designer PLC Designer (R3-1) Manual de usuario descargar pdf (Pagina 45)

L-force | PLC Designer

Lenze Specific Functions

 DMS 4.1 EN 03/2011 TD29 43

Inputs/outputs (VAR_IN_OUT)

Designator / Data type Info / Setting options

Axis Reference to the axis. Only one L_SMC_FreeEncoder axis is supported.

FastIO_Out Reference to the EPM S310 I/O compound module.

Inputs (VAR_IN)

Designator / Data type Info / Setting options

xExecute When a new positive edge is set, a new measurement is started. All

outputs of the block are reset to the initial values.

byDigitalOutputSel Selection of the output.

xOutputState Value to which the output is to be written.

lrSwitchPosition Position value at which the output is to be set. Since the position is

transferred in SoftMotion units, the reference transferred is an

AxisRef.

wExternalDelayCompensation The propagation times of the axis positions on the respective fieldbus

are not compensated automatically. This input can be used for setting

the manual compensation for the D0 output. The delay time is

entered in [µs].

Outputs (VAR_OUT)

Designator / Data type Value / Meaning

xDone This output is set to TRUE when the parameter has been written

correctly.

xBusy This output is set to TRUE as long as the writing has not been

completed.

xError This output is set to TRUE if an error occurs during writing. eError

outputs the cause of the error.

ErrorID Error number

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 116 117

Sin comentarios

Lenze PLC Designer PLC Designer (R3-1) Manual de usuario Pagina 45