Lenze TCF Series Manual de usuario descargar pdf (Pagina 45)

11 AUXILIARY STOP: When TB-13A is opened with respect to TB-4, the drive

will decelerate to a STOP (even if STOP METHOD is set to COAST) at the

rate programmed into Parameter 42 - ACCEL/DECEL #2.

12 ACCEL/DECEL #2: Selects the acceleration and deceleration time

programmed into Parameter 42 - ACCEL/DECEL #2.

NOTE

• In order for the RUN REVERSE and START REVERSE functions to operate,

Parameter 17 - ROTATION DIRECTION must be set to FORWARD AND

REVERSE (02).

• If a -10 to +10 VDC bipolar speed reference is being used (Parameter 07

- BIPOLAR REFERENCE SELECTION is ENABLED), the RUN and START

functions on TB-13A will only start the drive, they will not select direction.

Direction is determined by the polarity of the -10 to +10 VDC signal.

P11 TB-13B FUNCTION SELECT

This selects the function of terminal TB-13B. Closing TB-13B to TB-4 (or opening in the case

of setting 07) activates the selected function. The following functions can be selected:

01 NONE: Disables the TB-13B function.

02 0-10 VDC: Selects a 0-10 VDC signal (at TB-5) as the AUTO speed reference

input.

03 4-20 mA: Selects a 4-20 mA signal (at TB-25) as the AUTO speed reference

input.

04 PRESET SPEED #2: Selects PRESET SPEED #2 as the AUTO speed

reference. The drive will operate at the frequency programmed in Parameter 32.

05 DECREASE FREQUENCY: Decreases the speed setpoint when using the MOP

function. Refer to Section 10.6.

06 JOG FORWARD: Jog in the forward direction. In this mode, the drive will JOG

at the speed programmed into Parameter 32 - PRESET SPEED #2. JOG is not

available in Vector Torque mode.

WARNING!

When operating in JOG mode, the STOP terminal (TB-1), the AUXILIARY

STOP function (setting 07), and the STOP key on the optional remote keypad

WILL NOT stop the drive. To stop the drive, remove the JOG command

NOTE

If the drive is commanded to JOG FORWARD while running, the drive will

enter JOG mode and run at PRESET SPEED #2. When the JOG command

is removed, the drive will STOP.

07 AUXILIARY STOP: When TB-13B is opened with respect to TB-4, the drive

will decelerate to a STOP (even if STOP METHOD is set to COAST) at the

rate programmed into Parameter 42 - ACCEL/DECEL #2.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 75 76

Sin comentarios

Lenze TCF Series Manual de usuario Pagina 45