Lenze MCH Series Drives Manual de usuario

MCH Series Drives BACnet Communications Guide

7 RG-MHBACDrive Setup & Programming57 SERIAL This parameter needs to be set to either WITH TIMER (default) or W/O TIMER for the drive to com

RG-MHBAC 8BACnet Objects4 MCH BACnet® ObjectsThe MCH BACnet® Objects are divided into seven types: analog input, analog value, binary input, binary

9 RG-MHBACBACnet Objects4.2 Analog Input (AI) Object DescriptionsObject AI-1: Actual Frequency This object represents the actual speed of the dr

RG-MHBAC 10BACnet Objects4.4 Binary Input (BI) Object DescriptionsObject BI-1: Run / Stop Status This object indicates whether or not the drive is

11 RG-MHBACBACnet Objects4.7 Multi-State Input (MSI) Object DescriptionsObject MSI-1: Operational Status This object is for monitoring the actua

RG-MHBAC 12BACnet ObjectsObject MSI-3: PID Mode This object is for monitoring the general state of the drive’s PID mode as specified by Drive Parame

13 RG-MHBACBACnet ObjectsState Name Description Reference12 -VDC 0-10 VDC on TB-5A (Closed loop setpoint control - PID Enabled)13 -IDC 4-20 mA on T

AC Technology Corporation630 Douglas Street • Uxbridge MA 01569 • USASales: 800-217-9100 •Service: 508-278-9100www.lenze-actech.comRG-MHBAC-e2

This documentation applies to the use of an MCH Series Variable Frequency Drive with BACnet protocol and should be used in conjunction with the MCH Se

i RG-MHBACContents1 Safety Information ...

1 RG-MHBACSafety Information1 Safety Information1.1 Warnings, Cautions and Notes1.1.1 GeneralSome parts of Lenze controllers (frequency inverter

RG-MHBAC 2Safety Information1.1.4 Electrical ConnectionWhen working on live drive controllers, applicable national regulations for the prevention of

3 RG-MHBACIntroduction2 IntroductionThis document will explain how to operate an MCH Drive using BACnet protocol on a Master-Slave/Token-Passing

RG-MHBAC 4Drive Setup & Programming3 Drive Setup and ProgrammingMost drive parameters (including those required for serial communications) are n

5 RG-MHBACDrive Setup & Programming3.3 Modified Parameters and Selections24 AUTO SOURCE The default selection for this parameter has be

RG-MHBAC 6Drive Setup & ProgrammingNOTE• Drive Parameter #30 (CONTROL) must be set to SERIAL AUTO or S AUTO/NO HND in order to start the drive o